SkegPro Installation Guide

The SkegPro is very simple to install however to ensure a flawless installation you should follow the guidance below. Failure to do so may result in damage to your SkegPro and/or boat.

 

STEP 1

Using a mallet (leather, rubber or wooden), place the Megaware SkegPro on the skeg and gently tap on it to get it started.

 

 

---

Once in place, drive it on with the mallet until fully seated. Depending on motor application, the rear portion of the SkegPro could extend up to an inch beyond the skeg.

 

 

---

STEP 2

Using the predrilled mounting hole in the SkegPro as a pilot hole, drill the skeg using a 3/16" drill bit, and install the stainless steel hardware.

 

 

<< Go back to the SkegPro information page